The plate radiator requires no dead corners when doing anti-corrosion, and every inch of the inner wall must be complete, or it will be unimaginable, and a little loophole will be enough to cause a catastrophe. Nowadays, the materials of the protective film are also diverse, mainly resin Material is the main material. With other materials, the anti-corrosion technology of the radiator of the big factory is relatively safe. The use of self-developed, deep-sea type four anti-corrosion technology, strong corrosion resistance, the service life of the radiator is ten years Above, the arrogant protection of the interests of consumers. Active anti-corrosion technology is more common in the internal anti-corrosion of plate radiators, which is the fundamental solution to the anti-corrosion of plate radiators.

The anti-corrosion technology of plate radiator is to spray a protective film on the inner wall of the radiator to isolate the surface of the radiator from water and air. The corrosion of the plate radiator is mainly oxidative corrosion. The main problem of active anti-corrosion is strict control. The oxygen content in the heating water quality, through a series of controls to keep the oxygen content in the water at a reasonable level, to avoid corrosion, in the non-heating period, fill water for maintenance, avoid direct contact with the air, in this case, heat dissipation The general service life of the device is more than 10 years.